Sharp AR 5132 Service Manual Part 2 free download

File name Sharp AR 5132 Service Manual Part 2.pdf

SERVICE MANUAL CODE: 00ZAR5132TM1E DIGITAL COPIER NO.2 MODEL AR-5132 CONTENTS [ 1 ] PRINCIPLES OF THE DIGITAL COPIER . . . . . . . . . . . . . . . . . . . 1-1 [ 2 ] PROCESS SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1 [ 3 ] DEVELOPING SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1 [ 4 ] PAPER FEED SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1 [ 5 ] TRANSPORT AND FUSING SECTION . . . . . . . . . . . . . . . . . . . . 5-1 [ 6 ] HIGH VOLTAGE SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1 [ 7 ] RADF MECHANISM SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . 7-1 [ 8 ] DESK UNIT MECHANISM SECTION . . . . . . . . . . . . . . . . . . . . . . 8-1 [ 9 ] ELECTRICAL SECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-1 [10] RADF ELECTRICAL SECTION . . . . . . . . . . . . . . . . . . . . . . . . . 10-1 [11] DESK UNIT ELECTRICAL SECTION . . . . . . . . . . . . . . . . . . . . . 11-1 Parts marked with "!" is important for maintaining the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set. This document has been published to be used SHARP CORPORATION for after sales service only. The contents are subject to change without notice. CAUTION This copier machine is a class 1 laser product that complies with 21CFR 1040.10 and 1040.11 of the CDRH standard and IEC825. This means that this machine does not produce hazardous laser radiation. The use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This laser radiation is not a danger to the skin, but when an exact focusing of the laser beam is achieved on the eye's retina, there is the danger of spot damage to the retina. The following cautions must be observed to avoid exposure of the laser beam to your eyes at the time of servicing. 1) When a problem in the laser optical unit has occurred, the whole optical unit must be exchanged as a unit, not as individual parts. 2) Do not look into the machine with the main switch turned on after removing the developer unit, toner cartridge, and drum cartridge. 3) Do not look into the laser beam exposure slit of the laser optical unit with the connector connected when